SETUP DUAL CARBURETTOR DCOE / DHLA

SETUP DUAL CARBURETTOR DCOE / DHLA

• Remove the control arms (1) for the carburetors.
• Unscrew all damper / speed screws (2) completely.
• Check that all dampers and balance screws are fully closed (4).
• Screw in the damper screws (2) 1 turn.
• Unscrew the mixing screws (6) 2 turns from when they were completely closed.
• Refit the control arm.
• Start and run the engine until it warms up.
• Adjust the throttle screws (2) to the recommended speed
• Adjust the mixing screws (6) to the highest stable speed. Screw in (right) gives a leaner mixture and out gives a richer mixture.
• Use a syncrometer (item no. 98001) to balance the carburetors and adjust the balance screws (4).
• Readjust the damper screws (2) to the correct speed if necessary.

If you have any questions or concerns - contact us at MISAB at info@misab.se.

There is also a lot of information on our other channels Youtube, Instagram, Facebook and TikTok.